•
areas where the air contains chemicals or
particles such as grain, dust, or metal powders
•
any other area where you would normally be
advised to turn off your vehicle engine
Use with care
Use only in normal position (to ear). Avoid dropping,
hitting, bending, or sitting on the phone.
Keep phone dry
If the phone gets wet, turn the power off immediately
and contact your dealer. Water damage may not be
covered under warranty.
Resetting the phone
If the screen seems frozen and the keypad does not
respond to keypresses, reset the phone by completing
the following steps:
1.
Remove the battery door.
2.
Remove and replace the battery.
If the problem persists, return the phone to the dealer
for service.
Accessories
Use only Kyocera Wireless Corp. approved
accessories with Kyocera Wireless Corp. phones. Use
of any unauthorized accessories may be dangerous
and will invalidate the phone warranty if said
accessories cause damage or a defect to the phone.
To shop online for a Hands-free Car Kit and other
phone accessories, visit
www.kyocera-wireless.com/store
.
To order by phone, call (800) 349-4188 (U.S.A. only)
or (858) 882-1410.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Your service provider’s network controls the power of
the RF signal. This power level can range from 0.006
to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure guidelines
with safety levels for hand-held wireless phones.
These guidelines are consistent with the safety
standards previously set by both U.S. and
international standards bodies in the following reports:
•
ANSI C95.1 (American National Standards
Institute, 1992)
•
NCRP Report 86 (National Council on Radiation
Protection and Measurements, 1986)
•
ICNIRP (International Commission on Non-
Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by these
reports and the FCC guidelines.
E911 Mandates
Where service is available, this handset complies with
the Phase I and Phase II E911 Mandates issued by
the FCC.
Battery and charger specifications
Charger
Input
Output
CV90-60858-01 100-240VAC / 50/60Hz
4.5V 1.5A
CV90-60859-1
120VAC / 60Hz
5.2V 400mA
Standard Battery: 3.7V / 850mAh
