KYMCO Scout 50, Service Manual, Page: 8 / 188

2
. GENERAL INFORMATION
2-4
ZX / SCOUT
n
Do not squeeze wires against the weld or its
clamp.
n
After clamping, check each harness to make
sure that it is not interfering with any moving or
sliding parts.
n
When fixing the wire harnesses, do not make it
contact the parts which will generate high heat.
n
Route wire harnesses to avoid sharp edges or
corners. Avoid the projected ends of bolts
and screws.
n
Route wire harnesses passing through the side
of bolts and screws. Avoid the projected
ends of bolts and screws.
n
Route harnesses so they are neither pulled
tight nor have excessive slack.
n
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
n
When rubber protecting cover is used to
protect the wire harnesses, it shall be installed
securely.
n
Do not break the sheath of wire.
n
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.
n
When installing other parts, do not press or
squeeze the wires.
n
After routing, check that the wire harnesses
are not twisted or kinked.
Don’t touch