!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!
- 9 -
!
2.4
Change LED step:
ʳ ʳ ʳ ʳ
ʳ ʳ ʳ ʳ
ʳ ʳ ʳ ʳ
ʳ ʳ ʳ ʳ
ʳʳʳʳ
Remove the Volume knob by using the hot melt adhesive stick, drop the machine
cleaner onto the
LED Light transferring pole (Refer to picture 1.5),about 30s later, pick out of the
glue by using the tweezers, then take apart of the LED and welding by solder iron at
the constant temperature, check the LED polarity and add the solder ,then dispense
hot melt adhesive to fix the pole.
ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
!
!!!!!!!!
2.5
Change Audio wire and joint wire step
:
Confirm the corresponding Audio wire color before taking apart of the wire, drop
the machine cleaner at the yellow glue position every two or three minutes (repeat
this action about two or three times, then pick out of the yellow glue by using the
tweezers, heat up the wire joints, using the de-soldering tool till no solder exists on
the hole, then pull the audio wire.
Confirm the corresponding Audio wire color before fixing of the wire firstly, insert
the audio wire and add some solder ,then drop the glue on to the components.(refer
to picture 1.7)
)
picture
!2/6*
!
(
picture
!2/7*
!
Transferring pole
)
picture
!2/8*!
