
2-3/8"
(60mm)
or
2-3/4"
(70mm)
1-1/2
(38mm)
hole
2-3/4" (70mm)
1. Install latch and Strike.
Fig. 3
Fig. 1
d.
Leave the bolt in the extended position.
e.
Install strike with two 1-1/2” (38mm) wood screws (see
figure 5).
2. Remove cover and battery case.
2
Area
Crank
Use the checklist below to assure completion of important steps.
□ PREPARE DOOR AS REQUIRED ............
□ INSTALL LATCH AND STRIKE ................
□ INSTALL EXTERIOR ASSEMBLY ............
□ INSTALL MOUNTING PLATE ...................
□ ATTACH CONNECTOR ............................
□ INSTALL INTERIOR ASSEMBLY .............
□ RUN “BOLT DIRECTION” ROUTINE .......
□ PROGRAM CODE(S) ................................
□ VERIFY OPERATION ................................
On template (included)
Section 1
Section 3
Section 4
Section 5
Section 6
Section 8
Section 9 a, b, c
Section 9 d
a.
Determine your backset, see
figure 1.
b.
If a 2-3/4” (70mm) backset is
required,
extend bolt
and adjust
latch as shown
. (See figure 2).
Fig. 2
Fig. 5
Fig. 4
c.
Install latch, securing with small
wood screws (see figure 3).
Note: For
a 1-1/2” (38mm) diameter hole, test if
latch extends and retracts smoothly.
Area indicated may require addition
clearance for crank of latch to function
properly (see figure 4).
a.
Remove cover from assembly by sliding
cover up and off, see figure. 6
b.
Remove the battery case from interior
assembly by lifting the case up and out and
set aside, see figure 7.
Fig. 7
Fig. 6
Important before proceeding:
1.
Verify that position #2 of the “Settings
Switch” is in the
OFF
position. (Refer to section 11.)
2.
Work with the
door open (away from jamb) to avoid accidental lock out.
3.
Make sure
the bolt of latch is in the extended (locked) position.