2-5
Installation
54-0182 Rev. A1
11. With the corners secured, use the mounting plate
as a template to mark and drill the remaining
nineteen
3
⁄
16
" (5 mm)-holes through the roof of the
vehicle. Remove plate and clean roof surface. The
dimensions of the baseplate and locations of the
drill holes are shown in Figure 2-6.
12. Place the construction adhesive over all holes. If
using a liquid construction adhesive, apply bead
to mounting plate in a zig-zag pattern.
13. Reposition mounting plate over adhesive and
attach using
3
⁄
16
" (5 mm)-diameter rivets (or
appropriate fasteners). Seal all rivet heads and
edges with silicone.
14. Drill cable access hole(s) in vehicle.
15. When unit is installed with connectors facing the
rear of the vehicle, the drain holes are located as
shown in Figure 2-7 on the following page.
Figure 2-6
Mounting Plate Dimensions
