43
Step 2 - Enter the Gyro Offsets
Now you need to enter the offsets (which you
determined in Step 1) into the antenna.
1. Press the center MENU button on the ADCU
to access the onscreen menu (see Figure 64).
2. At “Setup display type?”, press NEXT until
the display shows “Setup Configuration?”
Then press ENTER and press YES to confirm.
3. At “Set brightness?”, press NEXT until the
display shows “Set Gyro offsets?”
4. At “Set Gyro offsets?”, press YES.
5. At “Set offset Pitch?”, press YES to go to the
Pitch screen. (Later, you will press NEXT to
go to the Roll or Yaw screen instead.)
6. At “Set Pitch”, use the - and + buttons to set
the pitch offset value. Then press ENTER.
7. Repeat Steps 4 through 6 to set the roll and
yaw offset values.
Setup display type?
Enter Next Return
Menu
Until “Setup configuration” shown
Set offset Pitch?
Yes Next Return
Set Pitch: +XX.X°
-
Enter
+
Set offset Roll?
Yes Next Return
Set Roll: +XX.X°
-
Enter
+
Set offset Yaw?
Yes Next Return
Set Yaw: +XXX.X°
-
Enter
+
Set Gyro offsets?
Yes Next Return
Set brightness?
Yes Next Return
Until “Set Gyro Offsets” shown
Use -/+ to set pitch offset
Use -/+ to set roll offset
Use -/+ to set yaw offset
At “ARE YOU SURE?,” press YES
Setup configuration?
Enter Next Return
Figure 64: Gyro Offset Menus on ADCU
Continued
Entering Sensor Offset Values
E
