Follow these steps to wire the belowdecks
equipment (see page 58 for a complete wiring
diagram).
Connect the supplied straight-through Ethernet
jumper cable from the B1 jack to the B2 jack
on the rear panel of the ICM (see Figure 39).
Connect the two supplied Wi-Fi antennas to the
rear panel of the ICM (see Figure 39).
a.
Connect the antenna data cable to the
supplied 16-position terminal strip connector
as shown in Figure 40.
b.
Place the terminal strip connector into the
base of the supplied cable shroud as shown in
Figure 41.
c.
Secure the end of the data cable to the base of
the shroud using the supplied clamp. This
clamp will help relieve stress on the cable.
Secure the clamp in place with the two
screws.
d.
Carefully fit all of the data cables wires
within the base of the shroud.
e.
Snap the shrouds cover onto the base. Be
sure not to pinch any wires between the cover
and the base.
f.
Plug the terminal strip connector into the rear
panel of the ICM.
g.
Connect the data cables ground wire
(attached to the grounding sleeve) to the
ground screw on the rear panel of the ICM
(see Figure 40).
The diagram refers to wires by
body color/
stripe color
. For example, Brown/White
means the brown wire with white stripe.
IMPORTANT!