TracNet H30 Installation Guide
30
Terminating RG-58 Cable
6.
Remove the debris from the end of the cable to
expose the braid, dielectric, and center conductor.
Carefully trim back any stray strands of braid that
extend into the area of the exposed dielectric.
Figure 54: Properly Stripped Cable
7.
Place the center pin into the crimp tool in the chamber
labeled “.068”. Then insert the cable’s center
conductor fully into the center pin. Crimp the center
pin onto the center conductor.
Figure 55: Crimping the Center Pin onto the Center Conductor
Figure 56: Center Pin Crimped in Place
8.
Gently flare the braid.
Figure 57: Flared Braid
9.
Insert the end of the cable into the neck of the
connector until the center pin and dielectric are firmly
seated inside. The connector should snap into place.
Figure 58: Pushing On the Connector
Figure 59: Connector Snapped into Place
Summary of Contents for TracNet H30
Page 1: ...Installation Guide TracNet H30...
Page 2: ......
Page 37: ...35 TracNet H30 Installation Guide Wiring Diagram Appendix E Wiring Diagram...
Page 39: ......
