54-0287
3.12
TracVision Receiver User’s Guide
3-5
Installing the Remote Control
Batteries
To install or replace the remote control’s batteries,
follow the steps below.
1.
Remove the battery compartment cover, located
on the back of the remote control.
2.
Insert two AAA batteries as shown, observing the
correct polarity.
3.
Replace the battery compartment cover.
7.
Press and hold the SAT button.
8.
At the same time, press the MUTE button for two
seconds.
9.
Release both buttons. The SAT button should
remain lit. If it doesn’t, repeat Steps 7-9.
10. Enter the desired ID number (“001” to “008”)
using the numeric keypad.
11. Press the SAT button to lock in the code.
12. Press the SELECT button twice.
The number to the right of the highlighted
Remote
ID
button will change to the new code. Check that
the ID has been set properly by testing the remote
control to ensure that it controls the satellite receiver.
Remote Control Batteries
