Crate packaging
37
Fitting the wheels
Follow the instructions below for fitting the wheels:
Chapter »Setting up work«, »Adjusting the rotor pitch«, page 57.
Chapter »Setting up work«, »Adjusting the rotor pitch for a single
axle«, page 58.
Chapter »Setting up work«, »Adjust the rotor pitch for a tandem
axle [+]«, page 59.
Fitting the rear wheels
The rear running wheels are pre-assembled complete with axle. The
axles are fitted directly onto the rotor chassis.
Fit the rear wheels onto both rotor chassis.
Tighten the axle nut to 250 Nm.
Fitting the front wheels
The front running wheels are fitted onto the double axles of both rotor
chassis, as shown below.
Tighten the wheel nuts on the wheels to 20 Nm.
Fit the outer wheel caps to the wheels.
Running wheel
Double wheel
No.
Quantity
Part
1
4
Rear running wheels 16 x 6.5 pre-assembled with axle
2
4
4 x M 20 nuts
3
4
4 x M 20 washers
No.
Quantity
Part
1
4
Front running wheels 16 x 6.5
2
4
Inner wheel caps
3
4
Sealing rings
4
4
M 13 washers
5
4
M 12 nuts
6
4
Outer wheel caps
Outer wheel cap
Wheel nut
Washer
Inner wheel cap
Nylon sealing ring
Front running
wheel