Kvaser Memorator Pro 5xHS User’s Guide
10 (27)
To operate the Kvaser Memorator Pro 5xHS in logger mode, you
must
supply
power through the CAN connector. To use the device as a USB CAN interface or to
configure the device, power on the USB side is sufficient.
See Section 4.4, CAN connectors, on Page 16 for information on how to connect
power to the connector. The supply power should be in the range specified in
Section 4.3, Technical data, on Page 15.
3.6
SD Card
You can use SD, SDHC and SDXC cards with your Kvaser Memorator Pro 5xHS
for logging. The Kvaser Memorator Pro 5xHS is built with industrial environments
in mind, but please note that the SD card used can be a limiting factor. By using a
quality card that matches the specifications of the Kvaser unit, you minimize the
risk for data corruption or lost data.
Insert the SD card upside down into your Kvaser Memorator Pro 5xHS (see
Figure 4). Do not apply excessive force.
To remove the SD card, open the access door and using a finger or a small coin,
gently press on the edge of the SD card until a click is heard. Release the card and
it will partially eject. Remove the SD card completely.
Figure 4: Inserting SD card into the Kvaser Memorator Pro 5xHS.
3.6.1
Write protection switch
Kvaser Memorator Pro 5xHS will
disregard
the setting of the write protection
switch on SD cards. This is by design. The intention is to minimize the risk of a
logging failure when the write protection switch is set by accident.
The setting of the write protection switch on SD cards is
disregarded by design. The Kvaser Memorator Professional will
write to the disk even if the write protection switch is set.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
