About Set Collars and Templates
2-19
KVAL DL-2DH Series Operation/Service Manual
2.
Trap bar in place by adjusting a second collar on opposite face of shaft holder. Col-
lars must be 1" apart center-line to center-line
3.
Kval recommends one set-up per shaft. There may be problems setting up a single
shaft to accommodate more than one door width.
• If more than one set-up is desired start with the widest door width set-up and work
towards the narrowest.
• You cannot set-up a centered light and an off-set light on the same shaft (collars will
interfere with each other).
4.
Move cutter head out to line-up index pointer (1/2" bar representing cutter diameter)
with the dimension of your first cutting pass nearest to the fixed fence.
• Jog the cutter head as close as possible to desired measurement, then manually push
carriage to achieve accurate line-up.
5.
Once tape reads specified dimension, install set collar, butted against out-board edge
of Travel Stop Bar.
Summary of Contents for DL-2DH
