
13
Troubleshooting:
Platter not rotating:
Motor controller unit- check if the red LED is on
-green display should show 33 or 45, if not re-plug PS DC
-unplug mains and check both connection cables from PS DC to motor
Consult dealer or qualified electrician.
Very slow start:
Remove the platter and belt and check position of the belt and tension.
Wrong speed:
Perform fine speed adjustment and check position of the belt. Be aware that fine speed
changes steps are very small.
If you find out that your speed selection is way out of range for some reason, you should
perform factory preset on PS.
Factory preset PS:
If the speed is totally incorrect and fine speed adjustment does not help: Reset to factory
preset and then adjust correct speed on the PS DC by using a strobe disc.
Turn the power off, wait 10 sec and then press and hold speed button, then press power on.
When display will shows CU, release the speed button. The display will now show FA and
then 33. Your PS is now reset for factory preset speeds.
**Perform fine speed adjustment.
If this fail consult your dealer. The problem will be probably be solved by a microchip
replacement.
Transportation:
For short distances dismantle the platter, remove belt from motor and disconnect all cables.
The base with the subplatter can be transported as one, providing that it will not be tilted, as
this may cause oil leakage.
All parts are heavy, however, and can be easily damaged by sliding around a transport
vehicle. Repacking in original cutouts and boxes is, therefore, recommended.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
Phone:+ 386 4 25 35 450
Fax: + 386 4 25 35 454
E mail: [email protected]
www.kuzma.si