ʎ
if the warning light stays on continuously, the engine will start and continue to run but the
low oil shutoff switch is not functioning properly. Check the switch for proper wire connections.
If the light continues to stay on, replace the switch.
ʎ
if the warning light does not flash quickly once, and the engine starts and continues to run,
the low oil shutoff switch is not functioning properly. Check the switch for proper wire
connections and grounding. If the light still does not flash when starting the machine, replace
the switch.
5.7 Proper Operation
See Graphic 3
Keep vibratory rammer clean and dry. Avoid no-load strokes. Never allow the rammer to
run full throttle when forcing away material or when lifting the equipment.
For optimal control, performance, and minimal hand/arm vibration, grasp handle as shown.
Hand/arm vibration (HAV) has been optimized for this positioning. Reported HAV levels are
measured at position A just in front of the hand position shown in conformance with EN1033
and ISO 5349.
CAUTION:
To prevent damage to the rammer, do not allow the rammer to run on its side.
If the rammer should tip on its side, place the rammer in the position shown, then shut off
the engine by turning engine switch to "
OFF
".
Graphic 3
5.8 Proper Compaction
See Graphic 4
5.8.1 Run rammer at the full throttle position (a2) for maximum performance.
5.8.2 Guide rammer with its handle. Allow machine to pull itself forward. DO NOT try to
over-power the machine.
5.8.3 For best compaction, the shoe must hit the ground flat (b), not on its toe or heel.
This will save on excessive shoe wear.
Summary of Contents for PDR80
Page 13: ...3 4 Label Locations Graphic 1 ...
