6.9 Options
6.9.1 Installing/Adjusting the Antitipper
There are two different sizes of antitipper for both the left and the right sides.
Allen key (3 mm, 5 mm) / Socket spanner (8 mm, 10 mm)
■■□
1.
Remove screws
A
and the lower part
B
of the axle
holder.
2.
Install the adaptation holder
C
using screws
A
.
3.
Mount the antitipper to the adaption holder using
screws
D
.
4.
Measure the distance between the antitipper and the
ground and adjust the length of the antitipper according
to the below description.
5.
Ensure that the rear wheels are parallel, see
A
=
7
Nm
(Low-strength)
D
=
9
Nm
Adjusting the length of the antitipper
1.
Press the spring pin
E
. Slide the inner part of the
antitipper to the required position until the spring pin
locates in the correct hole.
Function control:
The distance between the antitipper and the ground must
be 50 - 70 mm. It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the
axle is perpendicular to the antitipper’s point of contact with
the ground. In this position, the distance between the rear
wheel and the ground must be x ≥ 50 mm.
1659346-A
27
Summary of Contents for KSL
Page 30: ...Notes ...
Page 31: ...Notes ...