The KSL
1.
Remove the mudguard or clothes-guard on both sides.
2.
Remove the seat cover.
3.
Remove old backrest, see
6.3.3 Replacing the Backrest /
.
4.
On both sides, drill a new hole
A
in the frame with
a ø 6.1 mm bit, at a distance of 203 mm from the
rear-most hole
B
.
5.
Reinstall the seat cover.
6.
Install the seat tube
C
into the frame on both sides
using bolt
E
.
7.
Install the end plugs
D
into the end of both seat tubes
.
8.
Install the pre-assembled backrest to the seat tubes
using bolt
F
on both sides.
9.
Install the support plate
G
to the frame using bolt,
spacers and washers
J
.
10. Install the support plate
to the backrest tubes using
bolt
H
with spacer, washers and plastic washer
in the
required adjustor position, see section “Adjusting the
Backrest Angle” below.
11. On both support plates, insert the release cord into the
hole
K
and make a knot at both ends.
12. Position the mudguard or clothes-guard on the support
plate and drill through at position
L
.
13. Screw the mudguard or clothes-guard onto the support
plate with a torque of 7 Nm.
E
/
F
/
H
/
J
= 9 Nm
Adjusting the Backrest Angle
The backrest angle adjustor can be installed facing forwards
or facing backwards:
Installed facing forwards for backrest angles 82°, 86° and 90°.
Installed facing backwards for backrest angles 74° and 78°.
16
1659346-A
Summary of Contents for KSL
Page 30: ...Notes ...
Page 31: ...Notes ...
