Küschall® K-Series
Allen key (5 mm)
■■□
1.
Remove both rear wheels.
2.
Remove the bolts
A
on both sides and open up the
lower part of the axle holder
B
.
3.
Replace the axle
C
with a new one with the desired
wheel camber.
4.
Ensure that the rear wheels are parallel, see
Ensuring the rear wheels are parallel, page 33
.
5.
Close the lower part of the axle holder on both sides.
6.
Reinsert the bolts on both sides and tighten.
A
= 13 Nm
Installing a Vario-axle
Allen key (3 mm, 5 mm) / Socket spanner (8 mm)
■■□
1.
Remove both rear wheels.
2.
Remove the bolts, washers and nuts
A
on both sides
and remove the axle holder with the axle.
3.
Install the upper part of the Vario-axle holder
B
on
both sides using bolts, washers and nuts
A
.
4.
Insert the Vario-axle
C
and install the lower part of the
Vario-axle holder
D
on both sides using bolts and nuts
E
and bolt
F
.
5.
Set the desired wheel camber, see next paragraph.
6.
Ensure the rear wheels are parallel for wheel camber 3°
or 7°, see
6.7.1 Ensuring the rear wheels are parallel,
A
= 13 Nm
E
= 4 Nm
F
= 13 Nm
Adjusting a Vario-axle
—
■□□
1.
Loosen the knurled screw
A
on the Vario-axle.
2.
Pull the rear wheel by the wheel hub
B
until the
desired wheel camber is set. Possible settings are 1,
3, 7 and 10 degrees.
3.
Tighten the knurled screw again (not too tight).
36
1659339-A
