Küschall® K-Series
Installing/adjusting the active antitipper
Allen key (3 mm, 5 mm) / Socket spanner (8 mm) / Drill & drill bit (6 mm)
■■■
1.
Fit the holder
A
to the axle tube. Here, only lightly
tighten the bolts
B
.
2.
Remove the quick release pin
C
, slide the active
antitipper
D
over the holder and reinsert the quick
release pin.
3.
Turn the antitipper assembly around the axle so that it
matches the desired distance from the ground.
4.
Remove the quick release pin and carefully pull the
antitipper off the holder. The position of the holder
must not change.
5.
Reinsert the bolts
B
and tighten.
6.
For the aluminium axle, not for the Vario-Ax: Once the
holder
A
is correctly positioned, drill into the axle from
both sides through the corresponding hole in the holder,
insert the bolt
E
and secure with nut
F
.
B
= 7 Nm
F
= 7 Nm
The active antitipper cannot be fitted to a carbon
axle.
6.9.2 Installing/adjusting the transit wheels
Allen key (3 mm, 5 mm) / Socket spanner (8 mm)
■■□
1.
Loosen the bolt
A
and bolt and nut
B
and remove the
lower part of the axle holder
C
.
2.
Install the adaptation holder
D
with bolt and nut
B
and bolt
A
.
3.
Mount the transit wheel
G
to the adaptation holder
using the round nuts
E
and bolts with washers
F
.
4.
Ensure that the rear wheels are parallel, see
Ensuring the rear wheels are parallel, page 33
.
5.
Install the second transit wheel on the other side.
A
= 13 Nm
B
= 4 Nm
F
= 13 Nm
40
1659339-A
