3BA00174 • 2014-02-06 • Rev. 5
HR 100 1 / 38
6.
Description of function
6.4
Working with tool holder
6.4.1 Soldering and desoldering
■
Fasten the Hybrid Tool to the tool holder, for this purpose loosen the knurled screws
a
and open the mounting angle
b
. Push the Hybrid Tool into the receptacle
c
. The housing
of the Hybrid Tool must rest on the area
d
.
■
Fasten the mounting angle with the knurled screws. This locates the Tool.
■
Choose a suitable Hybrid adaptor and mount it to the Hybrid Tool. Then choose the pro-
gram matching the adaptor.
■
Lay the printed circuit board into the holder, fasten it and position it above the heating
plate.
■
Use the height adjustment feature to position the Hybrid Tool above the component to
be desoldered (distance 5...20mm). Loosen the knurled screw
e
and adjust the height.
Watch the height adjustment also on the scale
f
. Finally move the frame, until the
desired area is illuminated by the laser beam.
Caution!
Adjacent areas will also be heated and must therefore protected
against heat.
■
Soldering:
Prepare the soldering joint on the printed circuit board with soldering flux
and/or soldering paste. Then position the component.
