21
3BA00215 • 2016-07-11 • Rev. 3
ersa X-TOOL VARIO
Tip change using a tip holder:
■
Place the desoldering tip with its radially running
groove in one of the slots of the tip holder.
■
Secure the supporting stand with one hand.
■
Pull off the desoldering iron from the top with the
other.
■
To insert a new tip
, introduce it into the slot of the
tip holder and then insert it into the heat accumulator
.
■
The pin on the heat accumulator has to audibly snap
into the tip recess.
Tip change using tip changing pliers:
■
Using the tip changing pliers, grab the tip at the groove and pull it out
of the heat accumulator.
■
To insert a tip, grab it at the groove with the tip changing pliers and insert
it into the heat accumulator.
■
The pin on the heat accumulator must snap into the pin recess.
Caution! Material damage possible!
Do not twist the tip during extraction, otherwise the temperature sensor
could be damaged!
6.3
Desoldering
■
Run the tip of the desoldering iron over the component pin to be
desoldered.
■
Wait a short while until the solder that connects the component con
-
nector with the terminal pad is completely melted.
■
Now, activate the vacuum by pressing the corresponding button. The
solder is immediately conveyed through the soldering tip into the
residual solder pot.
Functional description
