3 to 6 months
1.
Open vise to maximum opening.
2.
Loosen the set-screw and remove the movable jaw.
3.
Remove spiral-retaining ring from handle end of the vise screw.
4.
Remove the screw support from the vise body.
5.
Remove the two-piece locking collar by removing the
four
SHCS.
6.
With one screw still half
-
way out spin off the first collar.
7.
Using a pin or screw reach into the second collar and spin it off
to
expos
e
the bearings.
8.
Remove the bearing
pack
assembly consisting of (2) thrust washers and
(1)
thrust bearing from the counter bore in the end of the body.
9.
Clean and inspect the counter bore, thrust washers and thrust bearing.
10.
Apply water resistant grease to the
bearing pack
(i.e. marine grade
grease)
11.
Install bearing
pack
assembly on the screw in the reverse manner.
12.
Install the first collar by
threading
on
to
the screw until it stops.
(
See Fig.
10
)
13.
Install the second collar behind the first and
thread
on until it stops. At
this
point the screw holes may or may not be lined up.
14.
Turn the second collar counterclockwise until a hole lines up.
15.
Then turn the collar back
TWO
(
2
) more screw holes. This will allow
proper
separation
for the collar
sections
to lock on the threads and keep the
bearings
firmly in place. (
See Fig.
10
)
16.
Install the
four
SHCS and tight
en in a star pattern.
17.
Install the screw support in the body on the screw (Hex end)
and secure
using the spiral retaining ring
.
18.
Your vise is now ready to use.
MAINTENANCE SCHEDULE
Fig.
1
4
22
Summary of Contents for VersatileLock 3800H
