Kurt VERSATILELOCK 3600H, Operating Instructions Manual

Page: 5 / 27

HYDRAULIC OPERATING INSTRUCTIONS
The 3600H/3610H can be operated hydraulically by hooking up the Kurt 6"
Hydraulic Unit with a typical hydraulic pump or an air over hydraulic pump.
Kurt offers a few solutions for hydraulic applications.
Kurt's KHP3 offers air
over hydraulics. Kurt offers other pump solutions and can be found on
kurtworkholding.com.
The hydraulic unit (KHU6), on the end of the 3600H/3610H, has a 1/4 inch
stroke. The KHU6 can be used in both single and double acting applications.
For single acting, a spring will return the vise to the opened position when
hydraulics are disengaged. If double acting is desired, both ports on the
hydraulic unit will need to be hooked up to a pump (See figure 2).
Fig. 2
CAUTION: ALL NPT CONNECTIONS IN HYDRAULIC SYSTEM MUST UTILIZE PIPE
DOPE, NOT TEFLON TAPE. TEFLON TAPE CAN GET DISLODGED BY FLUID AND
END UP IN PUMP OR UNIT, POSSIBLY VOIDING WARRANTY.
Note: A female #4 JIC fitting(s) is required at the end of the hydraulic line
to mate up with the male #4 JIC fitting(s) on the hydraulic unit.
5
HYDRAULIC SET-UP