In 18°C
INSIDE TEMPERATURE
Out 15°C
OUTSIDE TEMPERATURE
GREASE FILTER CLEAN
CHARCOAL FILTER REPLACEMENT
TIMER
ON / OFF
LIGHTS
RESET (COMBINATION OF KEYS)
MENU SELECTION
CONFIRMATION KEY
LESS
MORE
Cleaning the grease filter: special attention must be given to the grease filter which must be periodically cleaned,
whenever the grease filter alarm trips. For instructions of the filter Alarm, refer to the Controls paragraph. Wash the filter
with neutral detergent. Disassembly of the grease filter: Open the front panel, gripping it by the lower part and turn it
outwards to the end of its travel (Fig. 5) then gently release it until it locks. Remove the grease filter by pushing the catch
and turning it outwards.
Replacing the charcoal filters: if the filtering version appliance is used, the charcoal filters will have to be periodically
replaced when the charcoal filter alarm trips. For instructions on the filter Alarm, refer to the Controls paragraph.
Disasssembly of the charcoal filters: Open the front panel, gripping it by the lower part and turn it outwards to the end
of its travel (Fig. 5) then gently release it until it locks. Remove the grease filter by pushing the catch and turning it outwards;
remove the charcoal filters with a rotating movement (Fig. 17).
Lighting: Open the halogen lamp door by pressing on one side (where it says PUSH) and release (Fig. 18).
Replace with lamps of the same type. WARNING: do not touch the new lamp with bare hands.
Inside temperature measuring device: The hood is supplied with a device for measuring the inside temperature that
can be positioned anywhere in the room. The temperature measured is shown on the hood control panel display. If this
function is not active, use the controls on the hood as follows: press the “MENU” key, then press the - or + key until
the display shows “In 18°C” or similar; then press “ok”.
Outside temperature measuring device (optional): A device for measuring the outside temperature is available on
request, which can be positioned outside the building, protected from water (maximum distance on a direct line: about
15 m). The temperature found by the device is shown on the hood control panel display. If this function is not active, use
the controls on the hood as follows: press the “MENU” key, then press the - or + key until the display shows “Out 15°C”
or similar; then press “ok”.
The inside (and outside) temperature measuring device requires a 9V Transistor tyoe battery (not included).
If the temperature measuring device is eliminated, remember that the batteries must first be removed. Used batteries
must be disposed of properly, using the special containers.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. The symbol on the product indicates that this product may not be treated as household
Summary of Contents for KD9875.1
Page 8: ...1 2 3 4 5 ...
Page 9: ...6 7 8 9 10 ...
Page 10: ...11 12 13 14 15 ...
Page 11: ...16 17 18 ...
