18
EWIF 457.1
N.B.
: The primer must always be allowed to breathe for approx. 30 min.
subsequent to application.
4. Apply a line of Pactan along the inside of the cutout respectively (see
illustration).
The maximum processing time for Pactan is approx. 20 min.
5. Now insert the hob and position it.
6. Finally, fill the gap between the hob and the working top with Pactan.
7. Smooth the seam with a spatula and water with a low surface tension.
Alignment of the air channel
– Slightly loosen the screws of the air
channel.
– Push the air channel under the hob to the
rear against the back wall.
– Fasten the air channel with screws from
below.
Inserting the plug
– Insert the plug into the wall socket.
■
Any excess length of cable must be removed from the installation area.
Install a cover plate if required
– Installthe cover plate at an
installation depth of at least
220 mm (at least 20 mm
under the floor pan).
Do not apply too much
Pactan along the inner
edge.
Make sure that Pactan is
not pressed through to
the inside.
Fill in
