23
Instructions for assembly
Working surface cut-out
Cut out the worktop recess accurately with a good,
straight saw blade or recessing machine. The cut
edges should then be sealed so that no moisture
can penetrate.
The area is cut out as illustrated.
The glass ceramic hob must have a level and flush
bearing. Any distortion may lead to fracture of the
glass panel.
Make sure that the sealing of the hob is properly
seated.
The glass ceramic hob is fastened with clips or
with brackets.
Clips
• Drive the clips into the worktop cut-out at the
intervals indicated. It is not necessary to adjust
the height due to the horizontal stop motion
device.
Important! The horizontal drive of the clips must
be flush with the worktop (avoid the risk of
breaks).
• Position the hob according to the illustration on
the left side (1), align it (2) and insert the clips (3).
• Screws may be used to fasten the clips.
Brackets
• Insert the hob and align it.
• From the bottom, insert the brackets with
screws in the holes provided for fastening the
brackets, align the brackets and screw them
tight. Tighten the screws with a hand screw
driver only; do not use a battery-operated screw
driver.
• In the case of thin worktops make sure that the
brackets are correctly positioned. A metric screw
must be used on the bracket to balance it.
Important!
There is a risk of breakage if the hob is canted
or subjected to stress during installation!
Dimensions in mm
* Stainless steel frame 580
1
Minimum distance to adjacent walls
2
Cut-out dimension
3
Outer dimensions of the hob
4
Cable routing in rear wall
5
Installation height
