EEH 6100.1
27
– Carefully lever out the glass
cover with a screwdriver.
– Remove the faulty light bulb
and screw in the new one.
– Replace the glass cover.
Replacing the door
seal
[
Do not use the oven if the door seal is damaged or missing!
If the seal is damaged, or if it can no longer be cleaned, it must be replaced.
New seals are available from KÜPPERSBUSCH Customer service.
Unhooking the seal
– To remove the seal, start by carefully
unhooking it at each corner.
Fitting a new seal
– Insert the new seal one corner at a time into the oven front.
Take care not to bend the hooks out of shape!
Model identification plate
Should you need to contact Customer service or order spare parts, always
quote the information printed on the model identification plate.
The oven's identification plate is located just
inside the oven on the right hand side and is
visible when the door is open.
– Make a note of this information before you
consult Customer service.
You will find the rating label for the hob on the front page of the cooking
surface assembly instructions.
Installation instructions for fitter
■
Küppersbusch fitted ovens may only be connected to the corresponding
Küppersbusch fitted hobs by a qualified and authorised fitter.
■
Statutory regulations and the connection specifications issued by the local
power supply company must be strictly observed.
■
When carrying out repairs the unit must be disconnected from the mains.
Disconnect the fuse.
■
Ensure that all live connections are safely insulated when installing the oven.
■
The appliance may be connected only to a properly installed cooker socket.
Installing and wiring a cooker socket or replacing the connection cable should
only be performed by an electrician and in observance of the relevant
regulations.
■
Safety regulations require that an all-pole isolator with a contact opening of at
least 3 mm be used on the installation side.
■
This appliance can be placed with its back wall and one side wall next to
cupboard or room walls of any height. The other side may only be placed
next to a fitted cupboard of the same height at the most.
■
Built-in kitchen fixtures must be temperature resistant up to 100 °C. This
applies particularly to veneers, plastic coatings, adhesives, paint and
varnishes. Adjacent cabinetry front must be temperature resistant to at least
70 °C.
■
Make sure that the appliance is installed perfectly horizontally on a firm,
level base. The base must be perfectly rigid.
■
The kitchen unit must be fixed to the wall, using an angle bracket if
required.
Electrics
Built-in cooker
Permanent connection by means of a cooker socket.
Hob
Connected via the cooker connection strip.
Circuit diagram
for the various mains ratings is illustrated on the
back wall of the appliance.
Total rating
at 230 V: max. 10.8 kW, of which
oven: 3.5 kW,
hob: max. 7.3 kW (depending on the type)
at 235 V: max. 11.2 kW, of which
oven: 3.6 kW
hob: max. 7.6 kW (depending on the type)
Electrical connection
Permanent connection: 400 V 3 N
~
50 Hz
Connection 3 N
~
Fuse current 20 A
Connection 2 N
~
Fuse current 30 A
Connection 1 N
~
Fuse current 35 A
Connection 3 x 230 V Fuse current 25 A
Connection cable
use H 05 RR-F or H 07 RN-F.
Cable length
at least 2 m
Oven production number
Oven model type
