16
SERVICING
Always disconnect the appliance from the
electricity and gas mains before proceeding with
any servicing operation.
14) REPLACING HOT PLATE PARTS
When parts housed within the hot plate need
replacing, it is first necessary to remove the hot
plate itself from the cabinet, to overturn it, unscrew
screws “V” and to remove part “T” (see fig. 17).
After having carried out the above listed
operations, the burners (fig. 18), taps (fig. 19) and
electrical components can all be replaced (fig. 20).
NB:
the ignition bar must be removed before
replacing the taps in appliances with automatic
ignition systems.
It is advisable to change seal “D” whenever a tap is
replaced to ensure a perfect tightness.
Greasing the taps (see fig. 21 - 22)
If a tap becomes stiff to operate, it must be
immediately greased in compliance with the
following instructions:
- Remove the tap.
- Clean the cone and its housing using a cloth
soaked in diluent.
- Lightly spread the cone with the relative grease.
- Fit the cone back in place, operate it several times
and then remove it again. Eliminate any excess
grease and check that the gas ducts have not
become clogged.
- Fit all parts back in place, complying with the
demounting order in reverse.
To facilitate the servicing technician’s task, here is a
chart with the types and sections of the powering
cables and the ratings of the electrical components.
FIG. 20
FIG. 21
FIG. 22
FIG. 17
FIG. 18
FIG. 19
17
SERVICING
15) REPLACING THE BATTERY
To change the battery (see fig. 23) comply with
following instructions:
- Unscrew cap “T” and remove exausty battery.
- Insert a 1,5 V new battery. The positive polarity
“+” is turn over inside.
- Rescrew the cap “T”.
- Re-assembly all the movable parts.
WARNING:
The batteries contain a dangerous material for
our ambient. Always put them in a separate and
safe container.
If you eliminate your appliance, remember to
take off the battery.
FIG. 23
CAUTION
The device should not be operated for more than 15 second.
If after 15 second, the burner has not lit, stop operating the device & open the compartment door
and/or wait at least 1 minutes before attempting a further ignite of the burner.
In the event of the flame being accidentally extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least 1 minutes.
