EN
G
KÜPPERSBUSCH
reserves the right to make changes and corrections to its products as it
deems necessary, without altering their basic characteristics
.
During cleaning and maintenance work,
make sure the safety instructions set out
on page 10 are complied with.
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• The use of vapour cleaners is not
recommended.
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Fig. 3 (Page 39)
Proceed as follows:
• Remove the metal filters.
• Loosen the screws (A) to dismount the
cover top
(B)
.
• Change the broken/ burnt out lamp.
Maximum lamp power is 9W (E-14).
• Mount the cover top again
(B)
.
• Fit the metal filters.
Cleaning and maintenance
_________________________________________________________
Problem solving
Proceed with the following checks before calling the Technical Service:
Cleaning the hood body
Cleaning the metal filters
Changing light bulbs
Sizes and specifications
See page 38.
12
