12
Service Manual
For internal use only
6.1
Changing the halogen lamp
If the lighting does not work the lamps will firstly need to be checked and you will need to make sure that
the control switch on the control panel of the hood has not developed a fault.
The hood must be disconnected from the mains power supply before it is cleaned or
before any maintenance work is carried out.
Proceed as follows to replace a lamp or lamp mounting:
1.
Open the cover by levering it off at the
corresponding slits.
2.
Replace with a new lamp of the same type.
ATTENTION:
Never touch a new lamp with
your bare hands.
3.
Check the functioning.
6.2
Replacing the entire lamp block
1.
Use one of the two slits to lever out the lamp
block and remove it; make sure that the visible
parts are not damaged.
2.
Cut off the power supply and replace the lamp
block.
