56
EN
Water feeding
Filling the water tank
All functions require the water tank to be full.
Fill the water tank up to the “MAX” mark with cold, fresh
drinking water and introduce it into the slot located
above the cavity (approximately 1L).
Refilling the water
The contents of the water tank normally suffice for one
cooking session of 50-60 minutes.
If, however, the water tank needs to be refilled this is
signalled by the message meaning that the water tank
is empty.
Warning! Only fill the water tank up to a maximum of
0.5 litres to ensure that the water does not overflow
when it is pumped back to the water tank. RISK OF
OVERFLOW.
Emptying the water tank
When the appliance is switched off, the residual water is
pumped back into the water tank.
While the water is being pumped the display shows
“PUMP”.
This message stays on until the temperature of the
water reaches 75º C before it can be pumped back to
the water tank.
Warning: the water in the tank may be hot. Danger of
burns!
After the water is pumped back to the water tank, the
display will show the message “DEP” requiring the
following actions:
1.
Remove and empty the water tank.
2.
Dry the water tank and introduce it back into the slot
located above the cavity. Clean and dry the cooking
space.
3.
Leave the appliance door open so that the cooking
space can cool down and dry completely.
IMPORTANT NOTE: It is advisable to remove the water
tank and empty it after a cooking cycle. This prevents
the formation of bacteria and limestone inside the
appliance.
If the water tank has not been removed from the oven
and a new cooking cycle is started, the oven displays
the warning “DEP”.
This warning can be cleared by pressing the Stop key
and proceed with the new cooking cycle without
removing and emptying the water tank.