10
TECHNICAL PASSPORT
ENGLISH
Dishwasher
RINSE AID DISPENSER
1
To open the dispenser, turn the
cap to the «open» (left) arrow and lift
it out.
2
Pour the rinse aid into the
dispenser, be careful not to overfi ll.
3
Replace the cap by inserting it
aligned with «open» arrow and turning
it to the «closed» (right) arrow.
The rinse aid is released during
the fi nal rinse to prevent water from
forming droplets on your dishes that
can leave spots and streaks. It also
improves drying by allowing water to
sheet off the dishes. Your dishwashers
are designed to use liquid rinse aids. The
rinse aid dispenser is located inside the
door next to the detergent dispenser.
To fi ll the dispenser; open the
cap and pour the rinse aid into the
dispenser until the level indicator turns
completely black. The volume of the
rinse aid container is about 140ml.
Be careful not to overfi ll the
dispenser, because this could cause over
sudsing. Wipe away any spills with a
damp cloth. Don’t forget to replace the
cap before you close dishwasher door.
Attention!
Clean up any rinse aid split during
fi lling with an absorbent cloth to avoid
excess foaming during the next wash.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four
or six settings. Always start with the
dispenser set on «4» If spots and
poor drying are problems, increase
the amount of rinse aid dispensed by
removing the dispenser lid and rotating
the dial to «5». If the dishes still are not
drying properly or are spotted, adjust
the dial to the next higher number until
your dishes are spot-free. The dose is
factory set in position 5.
