Kuppersberg FQ3TG, Technical Passport

Page: 18 / 52

18
Technical passporT english
gas hob
If the ame is gone when you release
the switch You should repeat the above
process. But this time press the switch
and hold for about 10 seconds.
WARNING:
Do not use burning
system more than 15 seconds. If the
burner will not be burned within such
time or if the ame will be cut for any
reason whatsoever, repeat burning
process after waiting for 1 minute.
Closing the burners
Turn the control switch right-wise to
close the hob.
Flame Failure Device (FFD)
All burners on your hob are equipped
with Flame Failure Device system against
ame extinguishing risk (water ow, wind
etc.) When the ame was gone while the
burner switch is open such system will
prevent cutting of the gas supplied to the
burner. If the burning of the burner will
be cut due to safety, repeat the burning
operation by switching the burner switch
to off position.
Figure 8.
Using Right Burner
Â
The pan diameter and the
burner power should match in order to
ef ciently use it. The diameters proper
for each burner are given in the table.
Â
Select the proper pan diameter
and volume in order to de ne the
proper burner.
Pan Diameter
Burners
The Smallest
Diameter (cm) The Largest
Diameter (cm)
Auxilary Burner(A) 12 16
Semi Rapid Burner
(SR)
14 20
Rapid Burner (R) 18 24
Triple Burner 22 26
Usage of grills and
recommendations
The pan grills on the hob are
designed for safe use of the hob. Please
make sure that the grills are placed
properly and lastic legs t well.
Â
Do not use pans with the
deformed soles which may cause
instability on the grills.
Â
Use pans with proper diameters.
Do not use smaller pans in the diameter
of the burner. When small pans are used
it may cause over owing and reduced
the ef ciency of the hob.
Â
Do not cook with pans without lid
or semi closed pans to avoid energy loss.