12
TECHNICAL PASSPORT
ENGLISH
Electric Hob
1). Then simultaneously press the touch
buttons and
shown in the fi gure
(step 2). Next, press the power decrease
button
(step 3). The touch buttons
that you need to press vary depending
on whether the appliance has four or
fi ve hot plates.
When the control is reactivated, the
appliance will be ready to start cooking.
In the event of a power cut, the lock
function (if activated) will be cancelled.
Figure B:
Power surges
When the touch control system is
subjected to a higher voltage than the
usual ranges allowed in power grids,
the hot plates will disconnect and a
continuous beep will be heard. The
following message fl ashes on the hot
plate displays *:
400
When the nominal voltage is
reestablished, the beeping stops and
the message on the displays disappears.
The hot plates remain disconnected and
the
H
indicating residual heat remains
on the displays if these were on before
the surge. The appliance is then ready
to be used.
The touch control detects these
power surges whenever the appliance is
connected to the mains, even if it is not
being used at that moment. The alarm
described above might therefore be
activated even when the touch control
is switched off.
Unusually high power surges can
damage the control system (like with
any electrical appliance).
Tips for using ceramic hot
plates
Â
Use pots and pans with a heavy
and completely fl at base.
Â
Pans with a smaller diameter
than the shown heated area are not
recommended.
Â
Do not slide pots and pans over
the glass because they could scratch it.
Â
Although the glass can take
knocks from large pots and pans
withoutsharp edges, try not to knock it.
