or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of
obstruction. Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough water to pump for
air retard, in this case,
the water shortage indicator “ADD WATER” will light up, repress power
button to restart the ice maker is okay.
4. To ensure the cleanness of ice, please change water for water reservoir at least once one day. If
do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or interruption of power
supply, it will delay for 3mins to start up after restarted.
6. Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
TROUBLESHOOTING
1.
Please note, if a power failure occurs due to disconnection of the power cord, or the power button
has been pushed off during an ice making cycle, small ice chips may formed and lodge in the
automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the
power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then
restarting.
2.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket. If
not, please push the ice shovel gently by finger, then press “ON/OFF” button to restart.
PROBLEM
POSSIBLE CAUSE
SUGGESTED SOLUTIONS
The compressor works
abnormally with a
buzzing Noise
The voltage is lower than
recommended
Stop the Ice maker and do not restart
until the voltage is normal.
Water shortage indicator
light is on
1.There is no water
2.The pump is full of air
1.Add to some water until it reaches
MAX position
2.Press ON/OFF button to restart
Indicator lights on display
are not on
Blown fuse/ No power
Replace fuse / Turn power on
The Ice made is too large
and with pieces sticking
together.
Ice of previous cycles left in
the water tray
Take out the ice under the standby
state
The ice making process
was correct, but no ice
came out?
1. The compressor has
no refrigerant
2. Compressor damaged
3. Fan motor damaged
Call after sales service
7
