EN
WWW.BORMANNTOOLS.COM
9
Propellers
Propellers are easily damaged by hazards in the water, hitting the bottom and corrosion. Even slight damage can cause a
reduction in speed. Propellers on outboard motors are fitted with a shear pin, which is designed to break, if the propeller hits
a solid object. The pin is easily replaced.
If a propeller blade is bent or badly chipped, it is best to fit a new propeller as it will not work very well. Make sure you only fit
propeller, which is recommended by the outboard manufacturer.
Every three months, the propeller should be pulled off and the propeller shaft greased.
Periodic Inspection And Service
The following table is given as a guideline for periodic maintenance procedures.
These inspections and services are recommended for outboard motors used on an average of 20 hours per month. Depending
on operating conditions, the intervals between maintenance procedures may need to be changed.
Technical Data
Engine Type:
Single cylinder, 4 stroke, air-cooled
Displacement :
196cc
Bore x stroke:
70*51mm
Rated Power:
3.5kw/3600rpm
Start system:
Recoil start (manual start)
Fuel tank capacity:
1.3L
Engine oil capacity: 0.60L
Propeller diameter: 21.0cm
Running speed:
15--18km/h
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated
in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line
with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty
will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
Caution! For safety reasons the propeller system is supplied with no lubricant during delivery, please install angle transmis
-
sion grease before operating the machine.
Instructions on refuelling
The gasoline is highly flammable and explosive:
1.Don`t smoke,when refuelling,keep away from fire,flame and ignitions of other sources.
2.Shut off the engine of your outboard engine before refuelling.
3.Use unleaded gasoline only. Use 4 stroke engine oil.
4.Don`t spill the gasoline. Use clean cloth wipe off the spilled gasoline.
5.When start the engine,keep at least 3 meters distance from the refuelling point.
