8
remove the grill from the Cabinet.
Step 2-
Press-in the small silver push-in plugs
at location “B” on both sides. Press in the large
silver push-in plug at location “C” on the left side
only. These are holes that are used for side
shelves when the grill is used on wheels and are
not needed for Island installations.
Step 3-
At location “A” using 1/4-20 screws and
washers, attach the left side angle, leaving the
bolts loose for now. Orient the sides (left and
right) so that the studs attached to the angle
brackets are protruding outward at the back of
the grill. Bolt on right side similarly.
Step 4-
Install the front angle piece. With the
forked tabs pointing back, slide the forked open-
ing onto the front 1/4” bolt that is loose. Make
sure the fork is behind the washer as it is tight-
ened. Hold the front angle piece tight against the
grill front, and slide the left angle forward for a
close fi t. Tighten the bolt snugly. Repeat for the
right side and tighten.
Step 5-
Install the rear angle piece. Slide the
forked opening of the rear angle onto the studs
at the rear of the left and right angles. Install the
fl at washer and nut on the studs on both sides.
Holding the rear angle tight against the grill back,
tighten the nuts snugly. Tighten remaining 2 bolts
at “A” locations. Check bolt tightness on all fas-
teners. Do not over-tighten.
Step 6-
Route the power cable and control cable
down through the Island/Cabinet opening being
careful not to damage them when lowering the
grill into position. Remove grease drawers prior
to install.
You will need plenty of help to lower the grill into
the cavity as it is 200+ lbs. Place 2” X 4” blocks
at the grill opening corners for shims so that
fi ngers are not smashed against the counter top.
Lower the grill onto the counter top one side at a
time. Remove the plastic wrap securing the foil
trays to the grease drawer, remove one of the two
foil trays in each drawer and re-insert the draw-
ers.
Step 7-
Bring the control box up to the faceplate
from inside the island and fasten the control box
to the cabinet faceplate using the two 8-32 X 1/2”
screws. Fasten the faceplate to the cabinet front.
Plug the grill into the grounded outlet.
Step 8-
From inside the grill, insert the quick grill
zone linkage through the hole on the right side of
the grill. Attach the knob to the end of the linkage.
Step 9- At this time you may place a small
handful of pellets into the burn pot (see sec-
tion 3: step 2)
Install the diffuser drip tray. There
is a shelf at the front and back of the grill that the
drip tray rests on. With the quick grill zone linkage
pulled out of the way, set the drip tray in place as
shown in the picture below. It must be inserted
below the quick grill zone slide tracks at the front
of the grill fi rst then below the slide tracks at the
back. Once in place, push the tray all the way to
the back of the grill.
Step 10-
Place the quick grill zone cover onto the
tracks so that the linkage hole faces to the right of