KUHN Merge Maxx 900, Operator'S Manual

Page: 67 / 114

Instructions for work
Merger
Merge Maxx 900
65
- Pivot areas S and S’ in an angle X of 90° in relation to
beam (1).
Adjusting the wheel alignment ( Perform the operation
on each side of the machine ):
- Loosen counter nut (1).
- Remove nut (2).
- Remove screw (3).
- Remove roll pin (4).
- Remove washer (5)
- Remove pin (6).
- Adjust yoke (7).
- Reinstall pin (6).
- Check wheel parallelism.
Adjusting the wheel toe-in:
- Remove pins (6).
- Tighten yokes by 3.5 turns.
- Check the wheel toe-in (2.4°), B = A + 24 mm (1’’).
Readjust if necessary.
- Reinstall pins (6).
- Reinstall washers (5)
- Reinstall roll pins (4).
- Reinstall bolts (3).
- Reinstall nuts (2).
- Tighten counternuts (1).
Reinstall steering rod (1):
- Loosen counter nut (2).
- Adjust yoke (3).
- Reinstall pin (4).
- Tighten counter nut (2).
- Reinstall washer (5)
- Reinstall roll pin (6).
- Reinstall screw (7).
- Reinstall nut (8).