KUHN GA 3501 Super, Assembly & Operators Manual

Page: 27 / 36

- 25 -
OPTIONAL ACCESSORIES
1) SIGNALLING ELEMENTS (Kit No. 113 6220)
Signalling elements contribute to facilitating travel on public roads. Install the kit as follows :
- Bolt angle irons (2) to warning boards (1) with 6 hexagon bolts (3)(M10x25) and 6 self-locking nuts (M10) making
sure that the stripes are facing in the right direction (the upper outer corners must be red)(photo 36). Discard the
black and yellow decals which may have been supplied with the kit as these are required in Switzerland only.
- Attach both warning boards (1) to safety guards (4) with 2 hexagon bolts (3)(M10x25) and 2 self-locking nuts
(M10)(photos 35 and 37).
- Fix the right tail lamp (5) (marked “R” on the connector terminal) to the rear of right warning board (looking in the
direction of forward travel with the machine attached to the rear of the tractor) (photo 37).
- Fix the left tail lamp (6) (marked “L” on the connector terminal) to the left warning board’s rear side (looking in the
direction of forward travel with the machine attached to the rear of the tractor) (photo 37). The connector terminal
of the left tail lamp is also marked in white (photos 36 and 39).
- Apply the self-sticking red reflectors (7) to warning boards (1)(photo 37).
- Install grommet (8)(photo 38) and lay out wiring harness by proceeding as follows :
. Thread wiring harness through grommet (8).
. Withdraw electric cables for the tail lamps at (A) and route them through the interior of racks (10)(photo 39). Make
sure that the cable for the left tail lamp passes underneath the safety guard support before being threaded
into the left rack thus avoiding a situation where the cable can be trapped or stretched. The connector terminals
of the cables for the tail lights are marked “R” for the right lights and “L” for the left lights. The connector terminal
of the left tail light is also marked in white (photos 36 and 39).
. Fix the electric cables to the rear safety guards (4) using 6 clamp collars (11)(length 350 mm) and plug them
into the lamp terminals (photo 39).
NOTE : - Signalling elements require a 7 pin socket at the rear of the tractor.
- When detaching the implement, place plug (9) in its holder (12) (photo 38).