8. - Instructions for work
EL92-180/205/230
45
KN007CGB_F
Power tiller
With short skids
The working depth is set by the skid height.
The skids can be adjusted in 8 different positions:
- Lift the machine slightly off the ground.
- Lower and lock parking stand (3).
- Unscrew the 2 nuts (1).
- Remove screw (2).
- Position skid in hole corresponding to the required
adjustment.
- Reinstall screw (2).
- Tighten the 3 nuts (1) (2).
• Torque: 21 daNm (155 lbf ft).
- Proceed the same way on the other side.
- Adjust both sides to the same setting.
Relations between the working depth and the
skid position:
• (a) minimum: h = 40 mm
(1.5’’) (approximately).
• (b) max.: H = 180 mm (7’’) (approximately).
With standard skids
The working depth is set by the skid height.
The skids can be adjusted in 5 different positions:
- Lift the machine slightly off the ground.
- Lower and lock parking stand (3).
- Loosen nut (1).
- Remove screw (2).
- Position skid in hole corresponding to the required
adjustment.
- Reinstall screw (2).
- Tighten nut (1).
• Torque: 21 daNm (155 lbf ft).
- Proceed the same way on the other side.
- Adjust both sides to the same setting.
1
2
3
1
h
H
a
b
1
2
3
