EL92-180/205/230
44
8. - Instructions for work
KN007CGB_F
Power tiller
Working depth adjustment
With wheels
The working depth is set by the wheel height:
- Lift the machine slightly off the ground.
- Unlock and remove lynch pin (1).
- Remove pin (2).
- Position wheel arm in hole corresponding to the
required setting.
- Insert pin (2).
- Secure with lynch pin.
- Proceed the same way on the other side.
- Adjust both sides to the same setting.
Relations between the working depth and the
position of the wheels:
• (a) minimum: h = 50 mm
(2’’) (approximately).
• (b) max.: H = 250 mm
(10’’) (approximately).
Adjusting the distance between wheels:
- Lift the machine slightly off the ground.
- Loosen screw (1).
- Slide the unit to position the wheel in line with the
tractor wheel track.
- Tighten bolt (1):
• Torque: 8.5 daNm (63 lbf ft).
- Proceed the same way on the other side.
1
2
h
H
a
b
1
