4
Statement
The product is good packing when ship out the factory. All users should strictly abide by the
warnings and instructions stated in this manual, any damage and results due to misuse and the
neglect of this operating manual will be excluded from the deal responsibility this manual will not
informed in additionally if have technical changes.
1.
Safety information
1.1.
To guard against electric shock
•
Disconnect the fixture from AC power and allow the flash capacitor to discharge for 1 minute
before changing the lamp or fuse, and when not in use.
•
Do not remove the rear cover: there are no user-serviceable parts inside.
•
Always ground (earth) the fixture electrically.
•
Use only a source of AC power that complies with local building and electrical codes and has
both overload and ground-fault protection.
•
Do not expose the fixture to rain or moisture.
•
Replace the lamp only as described or have it replaced by a Strobe service technician.
1.2.
To guard against UV radiation, burns, and fire
•
Never operate the fixture with the front glass open, missing or damaged.
•
Do not stare directly into the light. Never look at an exposed lamp while it is lit.
•
Replace the lamp when it becomes defective or worn out.
•
When replacing the lamp, allow the fixture to cool for at least 10 minutes before
opening the fixture or removing the lamp.
•
Never attempt to bypass the fuse. Always replace defective fuses with ones of the
specified type and rating.
2.
Before using the product for the first time
•
Read safety information before installing, powering, operating or servicing the fixture.
•
Unpack and ensure that there is no transportation damage before using the fixture. Never
attempt to operate a damaged fixture.
•
If the fixture is not going to be hard-wired to a mains supply, attach a local power plug(not
supplied) to the end of the supplied power cable.
•
Before operating, ensure that the voltage and frequency of the power supply match the power
requirements of the fixture.(See specifications on the last.)
•
Verify that the power feed cable is rated for the current draw of all connected
fixtures.
•
Keep all combustible materials (for example fabric, wood,
•
Do not illuminate surfaces within 1 meter (39 inches)
•
Provide a minimum clearance of 0.1 meters (4 inches) around air vents.
•
Never place filters or other materials over the front glass cover.
•
The exterior of the fixture can reach temperatures up to 120° C (248° F).
