6
Issue 01 MAR.19
Step 18 - Fit the Slides
1a. Carefully lift the folding door
from the packaging and hold as
shown inside the enclosure ready to
offer into position.
a. Rest the side glass of the folding
door on your foot with the folding
door panels slightly opened.
Step 16 - Fitting the door
b. Swing door glass into “flat”
position and supporting gass by
hands, remove foot from under
glass, then offer glass into the
opening between the two fixed glass
panels. Rest the bottom edge of the
glass on the spacer block.
c. Now slide the glass door into
position central between the two
fixed panels so that the central
magnets top and bottom pull the
door glass into the frame. You will
feel the glass held in position by the
magnets when correctly positioned.
Step 17 - Secure Door Assembly
1.In order to position the door correctly, begin by moving the bottom hinge so that the fixed
panel glass fits snugly into the corner of the hinge bracket as indicated.
With both hinges held firmly in position against the fixed panel glass, fit 1 X M6x30 CSK Hex
Screws into the top hinge and fully tighten. Then fit 1 X M6x30 CSK Hex Screws into the
bottom hinge and fully tighten.
Open the door and discard the spacer block.
1. Acquire SF-BIF-SLID-998 from the installation pack and disassemble. Insert the top slide on
the closing side of the door into the rail by tilting the slide and lowering the rectangular slide
into the track of the rail. Tilt the slide and offer it into the rail as shown.
2. Now push up and into the Slide will run smoothly in the track when correctly fitted.
3. Position slide over centre of cut in glass and loosely secure with M6 X 16 Screw, do not fully
tighten at this stage.
4. Repeat the above to fit the bottom slide.
Step 19 - Adjust Slide Action
equal
equal
No contact
between rail
and slide
1. The sliding action should be smooth and running freely, If this is
not the case, slacken the bottom slide then position slide as shown
below. Now repeat for the top slide. This ensures there is no
pressure on the rails from the slides.
Position slides as shown below. Slides should be set so as not to
make contact with the rails at the top and bottom.
DIAGRAM OF TOP RAIL AND SLIDE
SHOWING CORRECT SETTING
Note: To allow smooth operation of the guides, apply Vaseline or appropriate lubricant to inside of
both
top and bottom rail
.
This glass edge
to fit neatly into
the corner of
the hinge here
Inside view
Inside view
Inside view
Inside view
Inside view
Inside view
