FIT TOP RAIL
Fit finial top assembly through hole at top edge of
glass panel using 4mm Allen key supplied, ensuring
screws are to inside of enclosure.
Protect shower tray by covering with suitable material
before fitting top rail.
TIP
ASSEMBLE TOP RAIL
Fit rail holder assembly and rail wall bracket to top rail
and locate over finial top(s).
Ensuring rail is horizontal, mark position of rail wall
bracket onto back wall.
Recess Top Rail- please ensure that the wall bracket
sits flush to the wall when positioning.
Note: the top rail is manufactured oversize, at wall
end, to allow for out-of-true walls. To ensure
correct fit, it may be necessary to trim the end of
the rail (the end with no pre-drilled hole), so that it
just clears the back wall when fitted.
FIX RAIL WALL BRACKET
Re-position wall bracket to wall and mark through
fixing hole.
Drill (8mm), plug and fix using No.12’s x 30mm long
screw provided.
Refit top rail assembly and tighten all screws using
2.5mm & 3mm Allen keys supplied, ensuring that the
shaped brass bush is fitted inside the top rail holder(s).
FIT COVER CAPS
Fit cover caps to top of channels using No.6’s x 10mm
long screws provided.
FIT BOTTOM SEAL (OPTIONAL)
Trim to length and fit seal to bottom of curved panel
glass, in between channel and bottom finial assembly.
- the soft flexible leg to face the outside.
Using damp cloth, wipe both sides of glass to ease
fitment.
Note: this seal is not required when using the
enclosure under normal showering conditions, ie.,
when the water is angled away from the panel.
However, if it is not fitted, please leave with consumer.
TIP
25
26
RAIL WALL
BRACKET
RECESS TOP RAIL
CORNER TOP RAIL
27
SIDE GLASS PANEL
CURVED GLASS PANEL
29
28
GRUB SCREW
FINIAL TOP
ASSEMBLY
CURVED GLASS
PANEL
SIDE GLASS
PANEL
RAIL HOLDER
ASSEMBLY