Kubota Super Series 2 KX 91-3, Operator'S Manual

Page: 32 / 98

OPERATION OF THE ENGINE 12
B
Charge Lamp
This warning lamp lights up if the charging system fails
while the engine is running. When the starter switch is
turned
"ON" with the engine off, the lamp lights up, and
when the engine gets started, the lamp goes out.
A
If there is disconnection or failure in the charging
system when the key is turned to
"RUN" , the following
symbol will appear.
B Oil Lamp
The engine oil pressure warning lamp lights up due to
failure of the lubricating system with the engine running.
When the starter switch is turned
"ON" with the engine
off, this lamp lights up, and when the engine starts, the
lamp goes out. If the lamp stays on with the engine
running, stop the engine and check the engine oil level.
A
If there is disconnection, failure or breakdown in the
lubricating system when the key is turned to
"RUN" ,
the following symbol will appear.
B Glow Lamp
With the starter key at the "RUN" position, the engine's
preheat status is indicated.
A
When the starter switch is turned to the "RUN"
position, the engine will be preheated for a given
period of time and the lamp will turn on.
A
The above indication appears momentarily when the
engine is started, but it does not mean any trouble.
(This is because the oil charge sensor output becomes
unstable when the engine is started.)
A
The symbol appears momentarily as the engine
starts. This is not an error.
B
LCD Display for Normal Operation
C Fuel gauge
To avoid personal injury:
A
Before adding fuel, be sure to stop the engine.
A Be sure to keep open flame away from the
machine. Otherwise a fire may be caused.
With the starter key at the " RUN " position, the fuel
remaining in the fuel tank is indicated in the block.
A
If the fuel gauge indicator is near the " E " or the " FUEL "
message appears, add fuel as soon as possible. If the
indicator is near "
E " and the machine runs on a slope,
the engine may run out of fuel and get interrupted.
C
Fuel supply
The following functions are helpful when adding the fuel.
The fueling progress can be monitored by a buzzer sound.
Procedure
1. Press the work light switch or the display selector
switch on the meter with the key OFF. (Keep the key
at OFF.)
2. The message shown above appears.
3. Add fuel.
4. The buzzer sound interval changes according to the
amount fuel added. As the fuel amount becomes close
to full, the buzzer sound changes to continuous
beeping.
(1) Fuel gauge (A) "Empty"
(B) "Full"