79
PERIODIC SERVICE
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A
To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
B
Changing Transmission Fluid
To avoid personal injury:
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to prescribed level.
A
Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
B
Changing Front Axle Gear Case Oil &
Front Differential Case Oil
1. To drain the used oil, remove the drain plugs at the
both front axle gear cases and filling plugs, and drain
the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil level check plugs.
4. Fill with the new oil up to the lower rim of check plug
ports on the both front axle gear cases.
5. Finally fill with the new oil up to the lower rim of check
plug port on the front differential case.
(See "LUBRICANTS" in "MAINTENANCE" section.)
6. After checking oil is visible through the openings of
three check plugs, reinstall filling plugs and check
plugs.
(1) Engine oil filter
Oil capacity
52 L
(1) Drain plug
(1) Dipstick
(2) Oil filling plug
(A) Oil level is acceptable within
this range
