Kubota M108DC, Operator'S Manual

Page: 108 / 124

PERIODIC SERVICE 88
EVERY 400 HOURS
B
Cleaning Water Separator
This job should not be done in the field, but in a clean
place.
1. Close the fuel shutoff-valve.
2. Unscrew the retainer ring and remove the cup, and
rinse the inside with kerosene.
3. Take out the element and dip it in the kerosene to
rinse.
4. After cleaning, reassemble the water separator,
keeping out dust and dirt.
5. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
EVERY 500 HOURS
B
Changing Engine Oil
To avoid personal injury or death:
A
Be sure to stop the engine before changing the
oil.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Fuel cock
(2) Retainer ring
(3) Cup (A) "CLOSE"
(1) O ring
(2) Element
(3) Spring
(4) Red float
(5) Cup
(6) Retainer ring
Oil capacity with filter 10.7 L
(1) Oil inlet
(2) Dipstick (A) Oil level is acceptable within this range
(1) Drain plug