Kubota KGZ770-MA1, Operator'S Manual, Page: 69 / 117

49 PERIODIC SERVICE
ENGLISH
B Checking Tire Pressure
To avoid serious injury or death:
A
Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Inflation pressure in front tires rises quickly
when using compressed air.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Do not use tires larger than specified.
B
Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
B Checking Transmission Fluid Level
To avoid personal injury:
A
Allow the transmission case to cool down
sufficiently when cleaning its surface.
1. Park the machine on a flat surface, lower the
implement to the ground and shut off the engine and
remove the key.
Allow the machine to idle for 1-3 minutes, and then
check fluid.
2. Raise and lock the operator's seat.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add the new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
A
If oil level is low, do not run engine.
Add the new oil to the prescribed level at the oil inlet.
Tire sizes
Recommended Inflation
Pressure
Front
15 x 6.0 - 6,
(Non Flat Tire) Rib
- - -
Rear
26 x 12.0 - 12,
4PR Turf
120 kPa
(1.2 kgf/cm , 17psi)
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
(1) Oil level dipstick
(2) Oil plug and breather cup (A) Oil level is acceptable
within this range.