OPERATING THE ENGINE
14
ENGLISH
CHECK DURING OPERATING
While operating, make the following checks to see that all
the parts are functioning normally.
B
Immediately Stop the Engine if:
A
The engine suddenly slows down or accelerates.
A
Unusual noises are suddenly heard.
A
Exhaust fumes suddenly become discolored.
B
Easy Checker (TM)
If the warning lamps in the Easy Checker (TM) come on
during operation, stop the engine immediately, and find
the cause as shown below.
Never operate the machine while Easy Checker (TM)
lamp is "ON".
Engine oil pressure
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker (TM) will come on.
If this should happen during operation, stop the
engine immediately and check level of engine oil.
B
Fuel Gauge
1. The fuel gauge shows the amount of fuel left in the LH
tank.
2. Refuel both the fuel tanks evenly.
3. If there is an amount gap between the LH and RH
tanks, the fuel in the bigger-amount tank will be
consumed first.
Fuel in both the tanks will be consumed at the same
time after the fuel levels of both the tanks become the
same.
A
Fill the fuel tank only to bottom of the filler neck.
A
Fill the fuel on a level ground.
A
Be careful not to empty the fuel tank. Otherwise air
may enter the fuel system.
Should this happen, the system should be bled. (See
"Bleeding Fuel System" in "SERVICE AS REQUIRED"
in "PERIODIC SERVICE" section.)
A
Only fill with gasoline containing less than 10%
ethanol content.
B
Fuel Pump
This fuel pump has a limit drive function.
A
When the key is in the "OFF" position: It does not work.
A
When you turn the key clockwise one notch, before the
engine starts: It works for about 15 seconds.
A
Keep the key in this position, before the engine starts.
It will stop working after 15 seconds.
And to reset the timer, keep the key in the "OFF"
position for about 60 seconds.
A
When the engine is running: It works normally.
(1) Easy checker (TM)
(1) Fuel gauge for LH tank
(E) "EMPTY"
(F) "FULL"
Summary of Contents for KGZ770-MA1
