Kubota AP-SR2772, Operator'S Manual

Page: 21 / 44

Section 1: Assembly & Set-up
Table of Contents
4/5/19 AP-SRF2772, AP-SRF2790, AP-SR2772, & AP-SR2790 Powered Rakes 321-120MK
17
Switch & Wire Harness For Kubota Skid Steer
Figure 1-9
Control Harness With Deutsch 2 Pin Plug
Refer to Figure 1-9:
323-096A . . . SWITCH & WIRE HARNESS DTP PLUG
This switch and wire harness is designed for attaching
the Powered Rake to Kubota Skid Steers when a 14 pin
Deutsch plug is not available and 2 pin Deutsch plug
located behind the driver’s seat is available. The 2 push
button control switch (#10) can be placed approximately
9 ft. from the solenoid valve.
Refer to Figure 1-10:
1. Attach Deutsch 2 pin plug (#9) to the Kubota male
plug (#11) located behind the driver’s seat.
Refer to Figure 1-11:
2. Fuse (#12) is supplied by customer. Install 10 amp
fuse (#12) in Kubota’s fuse box slot (#17) labeled
“Electrical Outlet-2”.
Refer to Figure 1-9:
3. The push button control switch (#10) is mounted
using the magnets on its back side. Locate and
mount this switch in a convenient easy to reach
location.
4. Connect power cord (#8) to control switch wire (#7).
5. Connect red wire plug (#3) to the bottom solenoid
connector (#4).
6. Connect green wire plug (#1) to the top solenoid
connector (#2).
7. Zip ties (#5) will be installed later.
8. Skip to “Operational Check” on page 18.
39767
Kubota Power Connection (Located Behind Drive Seat)
Figure 1-10
Installation of 10 amp Fuse
Figure 1-11
37389
9
11
37390
12
17