Kubota AP-SC2560, Operator'S Manual

Page: 17 / 48

Section 1: Assembly & Set-up
Table of Contents
12/18/19 AP-SC2560 & AP-SC2572 Skid Steer Rotary Cutter 326-836MK
13
Figure 1-1
Float Chain Assembly
Refer to Figure 1-1:
1. (Not Shown) Unbolt and remove shipping brace bars
extending from hitch plate to center of deck.
2. Attach clevis end (#1) of float chains (#4) to hitch
plate with 9/16" clevis pins (#2) and cotter pins (#3).
Bend cotter pin legs to keep them from falling out.
3. Install other end of float chains (#4) to deck with
1/2" clevis pins (#5) and 1/8" cotter pins (#6). Bend
cotter pin legs to keep them from falling out.
39167
IMPORTANT:
Make sure hydraulic hoses are routed
above the hitch plate as shown.
SC2560 Motor and hose Assembly
Figure 1-2
SC2560 Motor And Hose Assembly
Your skid steer Rotary Cutter is factory supplied with one
of three motors mounted to the deck. Make sure you
check the hydraulic flow rating on the deck motor decal to
verify it matches your skid steer’s hydraulic flow rating.
Skip assembly instructions below if the motor’s flow
rating matches.
See
“Motor and Hose Assembly” on page 28 to
properly select a motor that matches your skid steer.
Refer to Figure 1-2:
1. Remove fasteners (#1, 2 & 3). Keep fasteners for
reassembly of new motor.
2. Remove existing motor and hose assembly (#4).
Clean old gasket (#5) from gearbox flange (#6).
3. Place new gasket (#5) onto gearbox flange (#6).
4. Gently lower new motor and hose assembly (#4)
onto gasket (#5) with hoses extending towards the
hitch plate.
5. Secure hydraulic motor assembly with the four
existing 1/2"-13 x 2" lg. GR 5 hex head bolts (#1),
lock washers (#3), and 1/2"-13 hex huts (#2). Tighten
nuts to the correct torque. See
“Torque Values Chart
for Common Bolt Sizes” on page 40.
39168
Rout hydraulic hoses above the hitch plate as shown
in Figure 1-1.
IMPORTANT:
Rout hydraulic hoses above the hitch
plate as shown in Figure 1-1.